I’m not going to lie, the last couple weeks weren’t exactly riveting and so I have nothing too exciting to report back on, but fear not....the last week has been pretty busy, as you shall see.
Ok, so it’s the 5th Sept, we have just left Port De Cannes as today was the last day you could be in port, unless your boat is in the boat show, which we have decided not to be in.
The boat show is starting on the 9th and ending on the 15th Sept. Today is also the start of my 2 weeks at sea, as there are no available berths anywhere along the Riviera until about then!!! Crazy that!
Sept & Oct seem to be the months for boat shows, as first you have the Cannes boat show, then the Monaco boat show (23rd – 26th Sept), and then the Genova boat show (3rd – 11th Oct)! One of my fellow yachties is unfortunate enough to have to attend all 3 with her boat...a 130ft Mangusta.
Today was another day where it could have all gone wrong. After leaving port we anchored and prepared all our generators and watermaker. It all seemed fine until about lunch time, when I happened to walk past the engine room on my way to get lunch and saw that the entire engine room was engulfed in thick white smoke! My immediate thought was FIRE! I ran to the crew (who were all sat down with plates of food in front of them) and screamed “smoke in engine room”!...everyone jumped up and ran to the scene. My captain, was the first to enter and immediately requested that the generators be turned off, as this was the likely cause of the smoke.
It turned out that the generator was the cause, but it was due to a number of factors:
1) The cooling pipe had come loose and was causing the generator to overheat. Temperatures rose to about 120 degrees celcius!!
2) The sea cocks (which provides water to the watermaker and various other equipment, had been closed off from the sea, due to a blockage)
3) The muffler (silencer) had a hole in it, due to a small explosion caused by the pressure and heat, which meant that air was getting in, and also not allowing whatever water was in the system to flow in order to cool.
In our quest to find the problem, we cleaned all the sea cock filters, replaced impellers in generators, replaced the damaged muffler with a new one, which also had a defect, causing water to spray from the seam where the 2 parts of the muffler had been melted together! As well as filling up the with extra oil and water.
The day was long and hard and we ended up working a 13 hour day from 9am – 10pm. Sometimes this is necessary, as unlike a problem on land, a problem on a boat needs to be fixed immediately. In this instance it was the difference between having electricity & water or not, but in more severe cases, it could be the difference between sinking or staying afloat!
6th Sept....my 2nd day on anchor. We still had no generators working, except for the night/emergency generator which only supplies power to service and emergency batteries, which power lights, some plugs and the engines.
To be honest, I liked this day alot. As I couldn’t use any water and the boat was pretty clean as it was, I was able to get some “me” time and so caught some rays, learnt French
, fished and slept....yes, in that order! All in all a great lazy Sunday on my (well....the owners) boat.
Mon 7th Sept, weekend over and the start of the working week....or was it? Today, I pumped up the tender, as well as all the fenders. This seemed like enough work for the day, and so I decided to go for a swim, which didn’t turn out too good!
Although it had been about 8 years since I last free dived, I decided to head down to 10m. On surfacing, I had a lot of pain in my ears and sinuses, and then my nose started bleeding! It seems as though the pressure had been too much for me, as I was not “depth fit” and I probably did’nt equalize properly. About an hour or so later, I was all good.
Bleeding from the nose due to the pressure is’nt too bad, but if it had been from my ears, It would have been a different story.
Besides the 2 generators not working, we now had another problem……the emergency/night generator was overheating, and therefore all generators were stopped!
Rationing of water had now begun, as water reserves were middle to low range and watermaker was not working, as generators which power it were on the blink. If this was not enough trouble, the boats alarm system ( monitors fire, smoke, faults etc.) started going off and could not be silenced. After a complete boat search, we found that there were no problems and so had to disconnect all the censors one by one to find the wiring problem.
Tues 8th Sept, my 4th day on anchor. Our prayers were answered, as another, more experienced mechanic came onboard to fix our generator problem.
After connecting the dots, the mechanic simply took the sea cock filters out and stuck a stick down the sea cock (which opens up to the sea). What he found, was that the intake hole was blocked by mud barnicals and calcification from the sea water.
After we cleaned it out, the water started flowing again. This was the “big” reason why the generators were overheating! Proof that sometimes it’s the most simple things that cause the biggest problems.
Ok, so one problem down and a couple more to go. The watermaker was next on the list, and with the water levels not looking so healthy it was a biggie…………
After a technical overview, we found that it needed a new motor and pump. We replaced the filters in the meanwhile and awaited the new motor. At this point in time we only had 1000 litres of water, which sounds like a lot, but goes very quickly due to shower, washing up, toilet etc.
Got word today that we were going to be in the Cannes Boat Show tomorrow!!! It’s one of the most prestigious events on the yachting calendar, where hundreds of people (spectators and buyers alike) view the boats. Boats in the show range from small (10m) to Big (50m).
Wed 9th Sept and an early start……7am to be exact!
Although I had about 2 days worth of work, I managed to fit it into 1 day! I did a full wash down and exterior detailing (polishing stainless, polishing marks out, getting rid of rust etc.) so that “she” looked as pretty and as shiny as she could.
You’ll find that boats get dirty and dusty very very quickly, and so continuous cleaning and polishing is needed, especially when the owners are onboard, as they scrutinize everything.
Despite thinking that season was over and the owners were no longer coming onboard till next season (May), I received news today that the owner and 3 or 4 guests were coming on Friday!! Oh no…….!!
Thankfully, we received some good news in the form of a new motor and pump for the watermaker. No more rationing and a decent shower……awesome!
Thurs 10th September
Not too much to do today…..installed a new black water pump and that was about it really.
Boats have a black and Grey water pump system. Black water is all the waste from the toilets, and is named black water for a very good reason! The grey water is all the water from the shower and sink.
We have a touchscreen system onboard, where we can see all the different operating systems and levels of each tank, from freshwater to black and grey, as well as discharge them when needed. (Just make sure, you aren’t swimming when the black and grey tanks are discharged) Sometimes a sick, but funny (if it isn’t happening to you) joke captains play on the crew.
What I thought was going to be an easy day, turned out to be a late working night, as I got called to work at 8:00pm and ended at 12:00pm (chipping away foam insulation, in order to reveal some pipes where a new valve was going to be fitted.) I can’t say it’s the same for all boats, as some have start and finishing times for each day (ie. 8 – 5pm), but on my boat, anything at any time is possible!
Did you know: Boats designed for use in the Northern Hemisphere have longer anchor chains on the port side compared to the starboard side (providing they have two anchor systems). And vice versa for boats designed for use in the Southern Hemisphere. This is due to the fact that the wind in the north moves clockwise and the wind in the south moves anti-clockwise. This is why you will generally see boats using their longer chain side.
Fri 11th Sept,
Got up early and washed the boats hull and polished windows etc. Most hulls of boats are white, but I was unfortunate to get one with a navy blue hull. Although it looks very beautiful, the downside is that the blue shows up everything. Cleaning the sides of the hull is also not an easy task, as the angle is very difficult.
How do you clean the sides? Well, you can do it 2 ways:
1) Use the tender to go alongside the boat and clean the sides with an extendable pole and special soft brush head OR
2) Clean the sides (using the extendable pole and brush head) from the main deck. Make sure that the soap is washed off asap and before it dries, otherwise you’ll be doing it all over again!
Owner is still not here and is only supposed to arrive tomorrow now. Took it easy the rest of the day and just drove my Cptn. and the chef around on the tender to get supplies etc.
Sat 12th Sept,
Owner has still not arrived, and wondering if he’s ever going to come. In anticipation of him arriving, I polished windows and stainless.
Tip: Windowlene not only works well on windows/glass, but it also makes stainless steel shine like nothing else! White wine vinegar diluted with some water is also a good option for making stainless shine, but I still prefer windowlene.
We were approached by Port Security and told that we had to move a further 100m away from our current anchor site, as were all the other 100 boats out here. I still don’t know the reason, as this site has never been a problem.
Sun 13th Sept,
Woke up at 7:30am and started washing the aft (back) of boat, but was told by Cap (my captain shall now be reffered to as “Cap” from now on) that today was my day off, and that every Sunday is a day off! Hmmm…..best news ever!
What to do on day off when out at sea?? Hard one that……maybe boat watch, fish watch, sea watch??…..hmm…naaa, I’ll watch a couple “flight of the conchord” series (what a laugh) I then caught some shut eye, as sleep is always a good option on a boat, and should be taken when you can.
Lunch time was very interesting today. My Phillipino chef decided that i needed to try a popular Phillipino dish, fish soup. It's pretty tasty, so thought i'd share it with you!
Moved again, as storm had moved in and the spot where we were was getting too much swell.
We are now anchored between the 2 islands of Il St Marguerite, no swell and a great fishing spot!
That’s it from me for now....check back next week for new updates and pics.
Looking to get into the yachting industry and need more info re: courses?
Log onto: www.certifiedtraining.co.za
Email: courses@certifiedtraining.co.za
No comments:
Post a Comment